Quick Creation Of Lines; Quick Creation Of Ellipses - Walter Surface Technologies SURFOX Manual Del Usuario

5
Label creation
3. Drag in the bottom-right direction until the object size is correct.
4. The other method of positioning the rectangle object on the label is
selecting the Rectangle tool and then clicking the label. A default-sized
rectangle will appear, and you can resize it using handles around the object.
5. Note: If you want to draw a square, grab a handle on one of the rectangle
corners, simultaneously press and hold the Shift key, then resize the
rectangle. A square will be drawn.
6. To move a rectangle to a different position, select it and drag it elsewhere
on the label.
Lines
u
To place the line object on the label, do the following:
1. In the Toolbox, click on the Line object.
2. Define the line starting point by clicking the mouse at the start position.
3. Move the cursor to the end point while holding down the mouse button.
A line will be drawn from the left to right side of the label.
4. Note: To draw a vertical line, click the starting point and then drag the
cursor in the up-down direction.
Ellipses
u
To place the ellipse object on the label, do the following:
1. In the Toolbox, click the ellipse button.
2. Click the position on the label where you want the upper-left position
of the object to be set.
3. Drag to the bottom-right direction until the object size is correct.
4. The other method of positioning the object on the label is selecting the
Ellipse tool and then clicking the label. A default-sized ellipse will appear,
and you can resize it using handles around the object.
5. Note: To draw a circle, grab a handle on one of the ellipse corners,
simultaneously press and hold Shift key, then resize the ellipse. A circle will
be drawn.
6. To move an ellipse to a different position, select it and drag it elsewhere
on the label.
8