VERTBAUDET TSP106 Manual De Instrucciones página 38

Adjustment of height of the shoulder straps :
a) In the front of the car seat, unfasten the buckle and thread the straps through the openings
(photo 2 and 3).
b) At the back of the car seat, withdraw the straps and thread them through the openings of
which the height is good for the size of your child (photo 3). The 2 straps must be at the same level (pho-
to 4). The straps must pass through the plastic shell of the seat, the seat cover and the cushion (if any).
1
photo 2
2
WARNING ! Right strap goes through right-hand-side opening, Left strap goes
twisted.
INSTALLATION OF YOUR CHILD IN THE CAR SEAT
1. Unfasten the harness and place the straps outside of the car seat. Put your baby inside the car
seat. Ensure that your baby's back
and bottom fully rest on the car seat.
2. Sling the 2 shoulder straps over your baby
3. Insert the ensemble of the 2 buckles into
hear a « Click » sound. Verify that all are well
locked in place by pulling at different straps.
4. Adjust the harness to the size of your baby by pulling at the strap (A), the harness would then
retract to the body of your child. Leave only a small space between your baby and the harness. retract to the body of your child. Leave onl
To extend the harness, press the adjusting button, which is under the seat To extend the harness, press the adjusting
cover close to the crotch strap, and meanwhile pull the 2 shoulder straps
toward oneself. An indication - an imprinted circle - can be found on the
seat cover, signaling the location of the adjusting button.
WARNING: Ensure that all straps of the harness must be secured solidly in
whether it is in front of or behind the seat.
photo 3 photo 4
1
2
photo 5
2
1
5. To unfasten the harness,
press the red button on the
cental buckle.
EN
3
«Clic!»