Troubleshooting; Storage And Transport - Waeco PerfectView CSMarine Instrucciones De Montaje

RV-Marine-2.qxd 26.03.2004
– All plug connections must remain free from water. Otherwise, there is a dan-
ger of corrosion.
It is possible that the camera could be contaminated after use. Rinse the
camera with clear fresh water and do not use any detergents or scouring
agents. Make sure that the connecting plug does not come into contact with
water (see F 1).
Be aware that these are sensitive electronic devices. Therefore, the camera and
monitor should be treated with care.
No function:
No image:
Poor image:
Please keep in mind that the image quality of the system also greatly depends on the
water quality and the diving depth. It is possible that the system will give a better image in
a depth of 15 m and in clear water than in heavily soiled water and in a depth of 2 m.
– Use the supplied bag for storage. The cardboard insert from the package in
which your RV-MARINE/2 system has been delivered can be inserted into
the bag, and thus protects all components from damage.
– When not in use, the battery and system must be disconnected to avoid
excessive discharge of the battery.
– Prevent exposure of the monitor to water.
– Do not store the system in wet, very hot or extremely cold areas. The
storage temperature should not exceed or go below the temperature range
of –15°C to +60°C (see F 2).
11:40 Seite 23
Service

Troubleshooting

Is the supply cable connected correctly and firmly inserted?
Has the fuse activated?
Is the camera cable plugged firmly into the bushing?
Is the camera selection switch adjusted to the correct camera input?
Is the camera view window dirty?
Is the battery dead (the battery has enough voltage up to
approx. 11 V)?

Storage and transport

23