Quick Installation - BODEGA 43 Manual Del Usuario

1. Quick installation

1) Install the handle according to the following four steps:
a. Move the door seal just enough to put the screws in the holes in order to install the
handle, do not remove the door seal completely.
b. Attach the door handle with the screwdriver and screws that came with your
BODEGA43.
c. Return the door seal to the original position
2) If your shelves are tied together with tape for transport, remove the tape.
3) Leave a minimum of 5 cm between your BODEGA43 and the left and right walls and a
minimum 8 cm between the back of your BODEGA43 and the wall. Built-in models can be
placed directly against the walls around, while the front air vents remain free.
4) Wait at least 2 hours after your BODEGA43 is delivered before using it, and 10 minutes
between a small move and re-starting.
5) Ensure yourself of the correct voltage of 220V-240V/50Hz and connect your BODEGA43 to
the power supply.
6) The control panel of the upper zone can be used to switch the entire system on and off.
7) In case of dual temperature zones, the temperature of the upper zone must be set lower or
equal to the temperature of the lower zone.
8) Adjust the temperature zones to the desired temperatures.
9) Now your BODEGA43 is ready and it is time to store your wines. Check chapter 8: Loading
and storing wine bottles, to find out how to store your wines to achieve optimal long-lasting
quality.
3