Temperature Settings - BODEGA 43 Manual Del Usuario

iii. Leave a minimum of 5 cm between your BODEGA43 and the left and right walls and a
minimum 8 cm between the back of your BODEGA43 and the wall. Built-in models can
be placed directly against the walls around, while the front air vents remain free.
iv. Place your BODEGA43 on a flat surface. The feet of the BODEGA43 can be used to
cover small differences in height.
v. When placing the BODEGA43, make sure that the power cord is not trapped or
damaged.
d. Make sure that the ventilation area in your BODEGA43 is clear when you install it, otherwise it
reduces the capacity of cooling and heating.
e. Check the plug and cable before connecting the power supply and ensure the correct voltage
of 220V-240V/50Hz.
f. The control panel of the upper zone can be used to switch the entire system on and off.
g. In case of dual temperature zones, the temperature of the upper zone must be set lower or
equal to the temperature of the lower zone.
h. Adjust the temperature zones to the desired temperatures.
i. Now your BODEGA43 is ready and it is time to store your wines. Check chapter 8: Loading
and storing wine bottles to achieve know how to store your wines to achieve optimal long-
lasting quality.

6. Temperature settings

a. Your BODEGA43 works best at room temperature ranging from 0°C to 38°C (32F - 100F).
b. The temperature range inside your BODEGA43 is 5°C-20°C (41F - 68F). A single zone
BODEGA43 does not have a heating function, which means that the temperature inside can
never be higher than the outside temperature.
c. By pressing the temperature up and down buttons simultaneously for 5 seconds, the
temperature display mode changes between °C and F.
d. The temperature of the upper zone must be set lower or at the same temperature as the
lower zone.
7. The control panel explained
a. Single zone BODEGA43:
Switches the entire system on or off
Switches the LED light inside your BODEGA43 on or off
Raises the temperature
6