Publicidad
M.-Nr. 10717751
A
Monter toppladen.
A
Tilmeld modulet, se afsnittet Servicemodus i TSD'en til produktet.
A
Kalibrer doseringspumperne, se vejledningen i brugsanvisningen til produktet.
da
en-US
Installation instructions - Module 1, liquid dispensing 1 - 6
Reason: This module is required for connecting dispenser pumps for liquid dispensing to the washing machine.
Parts included
Quantity Mat. no.
Designation
1
EZL 235 electronic, module 1
4
Standoff
1
MFM 1-5 coding plug
1
MFM 53X coding plug
1
Plug N1Q_ST11A
1
"N1-1, N1-16 L, N" wiring harness
1
"N1-1, N1-16 bus" wiring harness
1
"N1-16_ST13, X3-4" wiring harness
1
"N1-16_ST11, Y39" wiring harness
1
Connection wire, blue 0.75 x 280
2
Raised-head screws, M4 x 10
1
Inlet valve, 3/4"
1
Hose
2
Hose clips, 8 - 16 mm
1
Beige 4-pin screw-terminal strip
1
Red 4-pin screw-terminal strip
1
Blue 6-pin screw-terminal strip
1
Green 7-pin screw-terminal strip
1
Orange/gray terminal strip 1X3-4
1
Blue/green/yellow terminal strip 2X3-4
1
Accessory module
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
11 von 30
16.03.2018
Publicidad
