Miele XCI-Box Instrucciones De Manejo Y Montaje página 35

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
Risk of electric shock caused by
the XCI box falling down off the wall
and into water.
If it is not secured properly and cor-
rectly, the XCI box can fall down off
the wall, causing an electric shock.
If an XCI box falls down off the wall,
it must be taken out of service imme-
diately. Replace the XCI box with a
new one or have it checked by the
Miele Customer Service Department.
Carrying out the installation
Service and repair work must only be
carried out by a suitably qualified elec-
trician in accordance with all appropri-
ate local and national safety regula-
tions.
 Disconnect the Miele Professional
machine from the mains voltage.
 Attach the XCI box to the wall using
the 4 screws (4 x 40) and plugs (S6)
provided. See Fig.  in the
"" chapter.
 Alternatively, the XCI box can be at-
tached to the wall using the adhesive
strips provided. See Fig.  in the
"" chapter.
 Establish the connection between the
XCI box and the Miele Professional
machine and the external hardware
(e.g. payment system).
When connecting external hardware
provided by other manufacturers, the
cable cross-section must not be less
2
than 1.0 mm
with a maximum cable
length of 2.50 m (98 ¹/₃").
Mounting the cable strain relief
The connection cables of external hard-
ware must be fastened to the XCI box
using cable glands and cable strain re-
lief fixtures. See Fig.  in the
"" chapter at the end of these operat-
ing and installation instructions.
 Remove the lid from the XCI box (re-
move the 2 screws).
 Remove one or more of the cable
strain relief fixtures a.
 Stand the XCI box on its narrow end
so that the sealed connection holes
are at the top.
 Using a screwdriver, press out the
round indentation in the connection
hole b.
Tip: Pierce through the groove round
the edge at several places using a
screwdriver.
 Insert the counter nut c.
 Screw on the threaded fitting d.
Tip: Slide the screw cap e over the
end of the connection cable for the ex-
ternal hardware.
 Guide the connection cable through
the threaded fitting and into the
XCI box.
 Tighten the screw cap.
The screw cap provides protection
against moisture and dust.
 Secure the connection cable with the
strain relief f.
 Make the required connections for
the external hardware in the XCI box.
 Close the lid on the XCI box (screw in
the 2 screws).
en - English
35

Publicidad

Tabla de contenido
loading

Tabla de contenido