Installation; Installation Dimensions; Pump With Float Switch; Pump Without Float Switch - Grundfos Unilift CC 5 Instrucciones De Instalación Y Funcionamiento

Ocultar thumbs Ver también para Unilift CC 5:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Installation

Do not install the pump hanging from
the electric cable or the discharge pipe.
Caution
Do not lift or lower the pump by means
of the electric cable.

9.1 Installation dimensions

9.1.1 Pump with float switch

If the pump is installed in a well, the minimum
dimensions of the well should be as shown in fig. 3
and the following table to ensure free movability of
the float switch.
Fig. 3
Minimum installation dimensions
Minimum installation dimensions
Height (H)
Pump type
[inch (mm)]
Unilift CC 5
20.5 (520)
Unilift CC 7
Unilift CC 9
22.4 (570)

9.1.2 Pump without float switch

The space required corresponds to the physical
dimensions of the pump, see page 28.
B
Width (B)
[inch (mm)]
15.7 (400)
19.7 (500)

9.2 Pump location

The pump can be used in the vertical position and in
the tilted or horizontal position with the discharge
port as the highest point of the pump.
During operation, the suction strainer must be
covered by the pumped liquid.
Fig. 4
Pump positions
Position the pump so that the suction strainer is free
of silt, mud or similar materials. This can be ensured
by placing the pump on bricks, an iron plate, etc.
Fig. 5
Pump mounted on a plate

9.3 Connection of discharge pipe

The discharge pipe can be connected directly to the
pump discharge port or by means of the adapter.
To prevent backflow through the pump when it stops,
the non-return valve supplied can be fitted inside the
adapter.
Fig. 6
Adapter and non-return valve
(position and function)
The adapter enables the connection of a pipe or
hose matching ¾", 1" and 1¼" NPT external pipe
thread. Cut off the adapter so that it matches the
discharge pipe diameter. If a gasket is used between
the discharge pipe and the adapter, the cut-off
adapter must have an even and smooth surface.
Please comply with local standards when connecting
the multifunctional adapter supplied to a pipe in a
permanent installation.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Unilift cc 7Unilift cc 9

Tabla de contenido