The Setup Menu Item; Standby; Wlan Access Point - Fronius Primo 208-240 3.8-1 Manual De Instrucciones

The Setup menu item

Standby

Manual activation/deactivation of the standby mode
-
-
-
-
-
-
-
Setting the standby mode (manual shutoff for feeding energy into the grid):
1
2
The display alternates between 'STANDBY' and 'ENTER.'
The Standby mode is now activated.
The Startup LED lights up orange.
Restoring the grid power feed operation:
In Standby mode, the display alternates between 'STANDBY' and 'ENTER'.
1
The 'Standby' entry is displayed.
The inverter also switches to the Startup phase.
After the grid power feed operation is restored, the Operation Status LED lights up green.
WLAN Access To activate/deactivate the WLAN Access Point. For example, this is required to set up or
Point adjust the system monitoring using the Datamanager web interface. If no Datamanager is
detected by the inverter, [not available] is displayed
Setting range
26
No energy is fed into the grid.
The Startup LED lights up orange.
The display switches between STANDBY/ENTER
In standby mode, no other menu item can be accessed or set in the menu level.
The automatic switching to the 'NOW' menu item after 2 minutes if no key is pressed
is not activated.
The standby mode can only be deactivated manually by pressing the 'Enter' key.
The grid power feed operation can be resumed at any time by pressing the 'Enter' key,
if no error (state code) is displayed
Select the 'Standby' entry
Press the 'Enter' function key
Press the 'Enter' function key

WLAN Access Point

[stopped]
Activate WLAN AP?
WLAN Access Point
[active]
The SS-ID (SS) and the password (PW) are displayed.
to restore the grid power feed operation
To activate the WLAN Access Point Press the Enter key