Installation And Use; Connecting The Module; Electrical Connection; Module Description - Miele professional XKM 3200 WL PLT Instrucciones De Manejo

Connecting the module

 Disconnect the Miele Professional ap-
pliance from the mains voltage.
 Plug the communication module into
the designated communication slot
on the Miele Professional appliance.
 Lightly press on the communication
module until it engages in its final po-
sition.
The module is ready for operation.
 Put the Miele Professional appliance
back into operation.
You can use the indicator LED on the
communication module to check its
status and that it has been installed
correctly.

Electrical connection

The communication module is supplied
with mains voltage via the Miele Profes-
sional appliance. No additional power
connection is required.
The Ethernet interface provided via the
communication module complies with
SELV (safety extra low voltage) require-
ments in accordance with EN 60950.
Connected external appliances must
also comply with SELV.
en - Installation and use

Module description

a Reset button
– Long press (5 s–9 s): resets the
module parameters to factory de-
fault settings and restarts module.
b Indicator LED
– LED does not light up: check that
the module is in the correct posi-
tion in the module slot.
– Lights up red constantly: module
is not configured.
– Lights up yellow constantly: net-
work is configured but there is no
connection to the network.
– Lights up green constantly: con-
nection to the network was suc-
cessful.
c Data plate (located on the side)
d Data cable
21