Publicidad
M.-Nr. 10222060
No.
Mat. no.
Designation
8
Bolt M6 x 25
8
Nut M6
4
Plug S12
4
Hexagonal-head wood screw 8 x 80
30
Underlay
4
Washer 38 x 4
4
Bracket
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
Risk of injury due to sharp edges
CAUTION
There may be a risk of injury due to sharp edges.
Risk of injury due to sharp edges!
A
Protective gloves should be worn and the edge protection, Mat. no. 05057680, should be used.
Plinth fitting
Fitting plinth on floor
A
Mark the positions for the holes to be drilled to secure the plinth. For this use the template in the lid of the machine
packaging.
A
Drill 12 mm dia. holes in the marked positions approx. 80 mm deep.
A
Insert plugs (4) in the holes, see Fig. 1.
A
Fasten the plinth to the floor with the hexagonal-head wood screws (1) and the 38 x 4 washers (2), see Fig. 1.
A
At the same time use the underlays (3) as necessary to compensate for unevenness in the floor, see Fig. 1.
Place the machine on the plinth
The arrow (2) embossed on the top of the plinth points to the front, see Fig. 2.
A
Place the machine on the plinth. Adjust the machine feet as necessary to level the machine.
A
Remove the front and rear panels from the machine.
A
Fasten the machine to the plinth with 4 brackets (1), each with 2 M6 x 25 bolts (2), 4 B6.4 washers (3) and 2 M6 nuts
(4), see Fig. 3.
A
Refit the front and rear panels on the machine.
A
With a closed plinth, fit the panels in accordance with the fitting instructions provided.
en
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
5 von 21
17.01.2018
Publicidad
