Descargar Imprimir esta página

Miele BSS 28 Instrucciones De Montaje página 3

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
M.-Nr. 10712541
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
Risk of injury due to sharp edges
CAUTION
There may be a risk of injury due to sharp edges.
Risk of injury due to sharp edges!
A
Protective gloves should be worn and the edge protection, Mat. no. 05057680, should be used.
Installing the peak-load cut-out kit
A
Remove the machine lid, see the model-related TSD.
A
Connect terminal block (1) on the wiring harness into its allotted position on the traverse. See Fig. 1.
A
Lay the wiring harness and place in cable holders (2). See Fig. 1.
A
Connect the wiring harness to ST33 (3) on electronic unit ELP 235. The existing bridge connector can be disposed
of. See Fig. 1.
A
Break off one of the covers at the top of the back panel for the cable gland.
A
Fit the cable gland in the top of the back panel.
A
Refit the machine lid.
en
cs
Montážní návod vypnutí ve špičce BSS28
Důvod: Montážní sada je nutná pro připojení praček konstrukčních řad PW4 a PW8 k systému vypnutí ve špičce.
Obsažené díly
Počet
č. m.
Název
1
kabelová forma N1L_ST33, X3-3
1
šroubení kabelu
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
3 von 16
16.03.2018

Publicidad

loading