Disposing Of This Printer - Brother MPRINT MW-120 Manual Del Usuario

Disposing of this printer

Before disposing of this printer, be sure to remove the built-in
lithium ion battery.
Removing the lithium ion battery
1
Turn off the printer, and
then disconnect the AC
adapter.
2
Using a screwdriver,
loosen the four screws at
the back of the printer,
and then remove the back
cover.
3
Disconnect the connector, and then remove the
lithium ion battery.
• Removing the back cover will void the warranty.
• The lithium ion battery is attached to the printer
• When unplugging the connector, do not pull on
• Risk of explosion if battery is replaced by incor-
Do not remove the back cover unless the printer
is to be disposed of.
with adhesive tape. When removing the lithium
ion battery, grasp it, and then pull it off of the
printer. Be careful not to pull on the cable.
the cable.
rect type.
Dispose of used batteries according to local regu-
lations concerning special waste.
Operating Procedures
Lithium ion
battery
Connector
15