Tool Use And Care; Specific Safety Rules For Metal Band Saws; Important - Surtek CM512 Manual De Usuario Y Garantía

IMPORTANT: This appliance is not intended
for use by persons (including children) with re-
duced physical, sensory or mental capabilities
may be different or reduced, or lack of experi-
ence or knowledge, unless such persons are su-
pervised or trained to operate the product by
a person responsible for their safety. Children
should be supervised to ensure they do not use
the devices as toys.

TOOL USE AND CARE

Do not force the power tool. Use the correct
tool for the application. The correct tool will
do the job better and more safely at the rate
that it was designed to work at.
Do not use tools if switch does not turn it on
or off. Any tool that cannot be controlled with
the switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and differential switch
when you are using an electric equipment.
12
SERVICE
Tool service must be performed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
METAL BAND SAWS
IMPORTANT: This manual is intended to fa-
miliarize you with the technical aspects of this
band saw. It is not, nor was it intended to be, a
training manual.
• Always wear approved safety glasses/face
shields while using this machine.
• Make certain the machine is properly ground-
ed before connecting.
• Before operating the machine, remove
tie, rings, watches, other jewelry, and roll up
sleeves above the elbows. Remove all loose
clothing and confine long hair. Do not wear
gloves.
• Keep the floor around the machine clean and
free of scrap material, oil and grease.
• Keep machine guards in place at all times
when the machine is in use. If removed for
maintenance purposes, use extreme caution
and replace the guards immediately.
• Make certain the switch is in the OFF position
before connecting the machine to the power
supply.
• Give your work undivided attention. Look-
ing around, carrying on a conversation, and
"horse-play" are careless acts that can result in
serious injury.
• Keep visitors a safe distance from the work
area.
• Never attempt any operation or adjustment
if the procedure is not understood.
• Keep fingers away from the blade when the
machine is running.
• Never hand hold material with the saw in the
horizontal position. Always use the vise and
clamp it securely.
• Keep belt guard and wheel covers in place
and in working order.
• Never force the cutting action.
• Do not attempt to adjust or remove tools
during operation.
• Always provide adequate support for long
and heavy material.