Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
LUBRICATION
Ball bearings on the blade guide assemblies
and the blade wheels are permanently sealed
and require no lubrication. Lubricate the vise
lead screw as needed with #2 tube grease.
Gear box oil will have to be changed after 90
days of operation. There after, change every
six months.
To change the gear box oil:
1. Disconnect ma-
Fig.15
chine
from
the
power source.
2. Place saw arm
in the horizontal
position.
3. Remove screws
(A, Fig. 15) from
the gear box and
remove
cover
plate and gasket.
4. Hold a container under the lower right cor-
ner of the gear box with one hand while slowly
raising the saw arm with the other. Drain com-
pletely.
5. Place arm in the horizontal position. Wipe
out remaining oil with a rag.
6. Fill gear box with approximately 1/2 pint of
MOBIL SHC 634.
7. Replace gasket and cover. Fasten cover with
bolts.
TECHNICAL DATA
VOLTAGE-FREQUENCY
CUTTING CAPACITY
CUTTING WIDTH
BLADE DIMENSIONS
POWER
WEIGHT
A
E N G L I S H •
120 V ~ 60 Hz
10 mm
15 mm
1 628 x 0,64 mm x 12,6 mm
550 W
55 kg (121 lb)
U se r ' s m an ua l
17
Publicidad
Tabla de contenido
