Step 3: Attach Wheel Assembly Cover; Step 4: Attach Legs; Step 5: Attach Weight Plate - Blue Rhino GWU511A Manual Del Usuario

Contact 1.800.762.1142 for assistance.
Do not return to place of purchase.

Step 3: Attach wheel assembly cover

A. Attach wheel assembly cover to base using 4 sets of medium screws (B), small lock
washers (L), small nut (H).
B. Tighten screws once all screws are in place.

Step 4: Attach legs

A. Attach legs to base using 6 sets of medium bolt (E), medium lockwasher (M), and
medium nut (I). Finger tighten only.
Note: Do not fully tighten until Step 6.
B. Attach small 'S' hook on Tank Restraint Chain to left leg.

Step 5: Attach weight plate

A. Lay base assembly on its side.
B. Insert weight plate into base, feet out. Secure using a 9/16" wrench, and 1 set of
carriage bolt (G), large lock washer (N), and extra large nut (K).
Note: If you plan to anchor your heater permanently, be sure to line up two outer holes in
base with those in weight plate so that your anchor bolt will pass through both holes.
C. Place base assembly upright.
Owner's manual: model GWU511A outdoor patio heater 8