Setup Mode - Ecler DP 300 Manual De Instrucciones

6. SETUP MODE

Once installed and switched on, the unit should be configured in order to choose the operating mode.
Starting from the welcome screen and pushing the PREVIOUS key once, the SETUP menu pages,
which configure the unit, can be accessed.
Following parameters can be adjusted from within the SETUP menu:
1. Operating mode: Mono, 2x3 ways, and 3x2 ways (LCR 2way). Stereo Link
2. Filter operating mode (Xover mode)
3. Delay units setting (Delay)
4. LCD contrast adjustment
5. Security Locks
6. MIDI operation
7. Delete Program
1. Operating Mode: Mono, 2x3 ways, and 3x2 ways (LCR 2way). Stereo Link
The 2-way LCR Mode (Left, Centre, Right) means that a third auxiliary channel called "centre" exists
apart from the standard left and right channels.
Starting from the welcome screen and pushing the PREVIOUS key will display following screen:
SETUP
CONFIG
If the encoder wheel is turned to the right or the ► key is pressed, the screens indicating all operation
modes will appear successively, and the MONO configuration can be changed to 2 or 3-way. The
processor is delivered in MONO mode by default.
Change to 3 way?
Enter to confirm
or
Change to 2 way?
Enter to confirm
Press the ENTER key to confirm the selection.
If 2-way is selected, following screen appears:
SETUP
CONFIG LCR 2 way
If 3-way is selected, following screen appears:
SETUP
CONFIG 2ch 3 way
MONO
9