Black+Decker BPWM16W Manual De Instrucciones página 15

ENGLISH
TROUBLESHOOTING & WARRANTY
SYMPTOMS POSSIBLE CAUSE
Staining Washer was not
unloaded promptly.
Clothes were not
properly sorted.
Wash cycle time The washer
is longer than automatically adjusts
usual the wash time for the
amount of laundry,
water pressure and
other operating
conditions.
Musty or Incorrect or too much
mildewy odor in detergent has been used
washer Inside of tub was not
cleaned properly.
Washer will not Power cord is not
turn ON properly plugged in.
House fuse is blown,
NOTE: If the washer
circuit breaker has
stopped during a
tripped, or power
cycle due to a loss of
outage has occurred.
power, the washer
House fuse is blown,
will resume the cycle
circuit breaker has
where it stopped
tripped, due to multiple
when the power is
appliances on one outlet.
restored.
Page 28
SOLUTIONS
Always remove items from the
washer as soon as possible after the
cycle is complete. Always wash dark
colors separately from light colors
and whites to prevent discoloration.
Never wash heavily soiled items
washed with lightly soiled items.
This is normal. The washer adjust
cycle time automatically to provide
optimal results for the selected
cycle.The time remaining shown
in the display is only an estimate.
Actual time may vary.
Use only High-Efficiency (HE)
detergent in accordance with the
manufacturer's instructions. Run an
Express cycle with bleach once a
month to clean tub and remove any
mold from inside washer.
Make sure that the plug is plugged
securely into a grounded,3-prong,
120-VAC, 60-Hz outlet. Reset
circuit breaker or replace fuse. Do
not increase fuse capacity. If the
problem is a circuit overload, have it
corrected by a qualified electrician.
Reset circuit breaker or replace
fuse. If more than one appliance
is connected to the outlet, call an
electrician to have an additional
circuit installed.
TROUBLESHOOTING & WARRANTY
SYMPTOMS POSSIBLE CAUSE
Water leaks Over sudsing of
detergent.
Poor stain Previously set stains.
removal
Washer will not Kinked drain hose. Drain
drain water located higher than 48
in. above the floor.
ENGLISH
SOLUTIONS
Over sudsing may create leaks, and
may be caused by the type and
amount of detergent used. High-
Efficiency detergent is the only
detergent recommended. Make sure
that detergent and any additives
are put into the correct dispenser
compartments. The normal amount
of detergent to use is 1/4 to of the
maximum amount recommended by
the detergent manufacturer. Always
reduce the amount of detergent if
the load is small or lightly soiled, or
if your water bis very soft. Never use
more than the maximum amount
recommended by the detergent
manufacturer.
Articles that have previously been
washed may have stains that have
been set . These stains may be
difficult to remove and may require
hand washing or pre-treating to aid
in stain removal.
Ensure that the drain hose is not
kinked. Make sure that the drain
hose is no higher than 4 ft. above the
bottom of the washer and is no more
than 5 ft. away from the washer.
Page 29