Maintenance & Safety - Nevir NVR-470 Manual De Instrucciones

CD/MP3 PLAYER OPERATION
This CD player plays Audio Discs including CD-R, CD-RW and MP3 files. CD ROMs, CDi, CDV, VCD, DVD
or computer CDs are not possible for playback on this set.
Note: Even if this portable radio-CD player is able to read CD-R and CD-RW discs, in addition to
conventional compact discs, it is not possible to offer a 100% guarantee that all CD-R/RW discs can be
read; playback depends on the quality and condition of the blank discs that you use, among other things. A
playback failure does not necessarily indicate that the unit is malfunctioning.
IMPORTANT: CDs encoded with copyright protection technologies by some record companies may be
unplayable by this product.
1. Adjust FUNCTION SELECTOR to CD/MP3.
2. To open the CD door, raise it by the corner marked OPEN/CLOSE.
3. Insert a CD with the printed side facing up and press the CD door gently to close.
(Display shows - – and later the total number of tracks)
4. Start playback by pressing PLAY/PAUSE.
5. Press PLAY/PAUSE to interrupt or resume playback.
6. To stop CD playback, press STOP.
NOTE: CD playback stops automatically when:
the CD compartment is opened;
the RADIO function is selected;
the CD is finished.
SELECTING A DIFFERENT TRACK
Press NEXT or BACK once or repeatedly until the desired track number appears in the display.
In the stop/pause position, press PLAY/PAUSE to start playback.
SEARCHING FOR A PASSAGE ON A TRACK
1. During playback, press and hold down BACK or NEXT. (The CD is played at high speed and low volume.)
2. When you recognize the passage you want release BACK or NEXT. (Normal playback resumes.)
NOTE: When your searching reaches the end of the last track, the CD goes to stop mode.
REPEAT
Repeat: playback of the current track continuously.
Repeat All: playback of the entire CD continuously.
PROGRAMMING OF TRACK NUMBERSYou may store up to 20 tracks (in CD mode)or 99 tracks(in
MP3/USB mode) the desired sequence. If you like, store any track more than once.
1. In STOP mode, press PROG to activate programming. (Display: PROG and "P01" flash.)
2. Press BACK or NEXT to select your desired track. (Display: PROG and your desired track number flash.)
3. Press PROG to store the desired track number. (Display: PROG and "P01" flash for you to program the
next track.)
4. Repeat stop 2 to 3 to select and store all desired tracks in this way.
5. To play your program, press PLAY/PAUSE. (Display: PROG flash during program playback.)
NOTE: If you try to store more than 20 tracks, no track can be selected and the display will show flashing CD
FUL or MP3/USB FUL.
PROGRAM CHECK
In STOP mode, press the PROG repeatedly to see your stored track numbers.
DELETING A PROGRAM
Perform the following operations to delete the memory:
open the CD door;
select the RADIO source;
press STOP once.
ENG-8
MAINTENANCE & SAFETY
SAFETY INFORMATION
Place the unit on a hard, flat and stable surface so that the system does not tilt.
Do not expose the unit, batteries, CDs to humidity, rain, sand or excessive heat caused by heating
equipment or direct sunlight.
Do not expose the apparatus to dripping or splashing.
Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding
surfaces is necessary to prevent heat build-up.
The ventilation should be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc...
No objects filled with liquids, such as vases, shall be placed on the apparatus.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
The mechanical parts of the set contain self-lubricating bearings and must not be oiled or lubricated.
To clean the set, use a dry cloth. Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
CLEANING CDs
Use a soft and clean cloth to wipe away fingerprints or dust from the surface of the disc.
Wipe in a straight motion from the center to the edge. Very small dust particles and slight smudges
have absolutely no effect on the sound quality.
Never use chemical products such as sprays for conventional (vinyl) records, anti-static aerosols,
benzene or thinners to clean your CDs.
To reduce the risk of scratches, always store CDs in their case when not used.
Do not expose CDs to direct sunlight, high humidity or excessively high temperatures for long periods
of time.
Never write or affix labels to the CD's surfaces.
CLEANING THE LENS
If the lens is dirty, the sound may skip and the CD may not be read correctly. Open the CD door and clean
the lens as follows:
Unplug the power cord.
Dust or dry particles:
Blow on the lens several times using a camera lens brush, then wipe it gently with the brush to remove
the dust. Then blow again on the lens.
Fingerprints:
If you are unable to clean the lens with the camera lens brush, use a dry cotton swab to clean the
surface, from the center to the outside.
ENG-9