TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following hints, consult your dealer or service center.
WARNING:
Do not open the unit as there is a risk of electric shock. Under no circumstances
should you try to repair the set yourself; as this will invalidate the guarantee.
Problem
Possible cause
Remedy
No sound/power
Volume not adjusted.
Adjust the volume.
Power cord not securely connected.
Check the AC power cord properly.
Batteries dead/incorrectly inserted.
Insert (fresh) batteries correctly.
CD contains non-audio files.
Press BACK or NEXT once or more to skip to a
CD audio track, instead of the data file.
Display does not function properly/No reaction
to operation of any of the controls
Electrostatic discharge.
Switch off and unplug the set. Reconnect after
a few seconds.
The CD skips tracks
CD damaged or dirty.
Replace or clean CD.
Program is active.
Quit program mode.
Environmental information
All unnecessary packaging materials has been omitted. The packaging can be easily separated into three
materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging, dead batteries and old
equipment.
Notes:
Make sure the CD is not encoded with Copyright
protection technologies, as some do not conform
to the Compact Disc standard.
- - indication
No CD inserted.
Insert a CD.
CD badly scratched or dirty.
Replace/clean CD, see Maintenance.
Laser lens steamed up.
Wait until lens has cleared.
CD-R(W) is blank or not finalized.
Use a finalized CD-R(W) or suitable CD Audio
disc only.
ENG-10
SPECIFICATIONS
Power supply
: AC 230V~50Hz
: DC 9V
6 x UM-2/R14 batteries (not included)
: 12 Watts
Power consumption
: 185(L) x 186(W) x 123.7(H) mm
Dimensions of unit
: 1.14kgs
Weight
: AM 540-1600kHz
Frequency range
: FM 87-108MHz
: 1.2W x 2 RMS
Output power (RMS)
: 8 ohm
Speaker
: ø 3.5mm
Headphone
(The technical characteristics are liable to change without notice)
In order to fulfill ruling UNE EN-60065, we indicate that if the flexible wire is damaged, it can only be
substituted by a technical service recognized by NEVIR, S.A., as per special tooling is required'
Recycling
This symbol bears the selective sorting symbol for waste electrical and electronic
equipment (WEEE). This means that this product must be handled pursuant to
European Directive 2002/96/EC in order to be recycled or dismantled to minimize
its impact on the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are
potentially dangerous for the environment and human health due to the
presence of hazardous substances.
ENG-11