NEO TORCH 4000 Manual De Usuario página 7

5. LASER SAFETY FIRST!
• Before proceeding any further, please read the
following safety page very carefully. It could
help you avoid dangerous and hazardous
situations which could lead to serious injury or
property damage.
• Any laser system classified as a Class 4 laser
must be used with caution. If you are not an
experienced laser operator we would strongly
recommend that you attend a laser display
safety course as soon as possible, and ideally
before this laser system is used in pubic areas.
There are various places in Europe where you
can attend quality training and even a one day
course will give you a good amount of valuable
information to safely startwith.
Unless you are very competent with the use of
lasers and about the laser safety, make sure you
follow thesebasic laser safety rules:
1. Never look directly in to a laser beam.
2. Never look directly in to laser aperture if the
6. INSTALLATION OF THE SYSTEM
• The manufacturer is not liable for damages or
a injury caused by improper installation of the
system. The installation should be carried by a
qualified installer who should follow the Laser
Safety Regulations of respective country.
Please follow these rules during the installation:
1. Do not connect the device to power supply
during the installation.
laser system is switched on.
3. Be aware that lasers can burn the eye retina,
skin or cause fires if not used correctly.
4. Never perform Audience Scanning – that's
when laser beams and effects hit an audience
directly. Always project with the laser above
audience head level – at least 3m above floor
level.
5. When performing outdoors, avoid pointing
the laser at aircrafts, buses, trains, etc.
6. Never leave the laser system unattended
when it's switched on.
7. Always check for reflective surfaces within the
laser range – these can be very dangerous (i.e.
mirror behind the bar in a club could bounce
the beam in to bar attendant's eye).
8. Never hesitate to use the Emergency STOP if
you think there's a fault within the laser sys-
tem or a potential danger to a person/object
caused by the laser performance.
2. Mount the system only to mounting point that
is strong, secure and away from places where
non-authorised person could get an accessto.
3. Always make sure the system is properly
tighten down and that it cannot get loose and
move as a result of sound vibrations, cable
pull or similar.
4. Always use a safety rope.
5. Ensure that all the cables have enough lever-
P. 7
- Neo Torch 4000
English version