Trouble Shooting - FujiFilm Zoom Date 90EZ Manual De Instrucciones

TROUBLE SHOOTING

During operation
Problems
The shutter release won't
trip.
" " is blinking after loading
the film and closing the
camera back.
After loading the film and
closing the camera back,
the film is rewound and " "
is displayed.
The film rewound during
photographing.
The self-timer cannot be
set.
" " is blinking and the shut-
ter can not be released.
42
Possible Causes
1 "
" symbol is blinking.
2 Power switch is not on.
3 Is "
" blinking on the LCD?
4 "
" is displayed on the picture coun-
ter.
●
Did you pull the end of the film out to
the FILM TIP mark when loading the
film?
●
Did you open the camera back so as
to remove the film without checking that
the motor has stopped and that "
displayed?
●
Did you press the
middle of the film?
●
Is the date correction mode on?
●
The camera is broken.
1 Replace the new batteries.
2 Press the POWER button.
3 The flash is charging. Wait until "
and is displayed. (The flash takes about 7 seconds
to charge.)
4 Remove the film, and load an unused roll.
●
Pull the end of the film out to the FILM TIP mark
and correctly load the film.
●
Check that the motor has stopped and that " " is
displayed. After that, open the camera back and
" is remove the film.
●
button in the Be sure not to move the
loaded in the camera.
●
Cancel the date correction mode.
●
Please contact a FUJIFILM authorized distributor.
Solutions
" stops blinking
button while film is
ENGLISH
Page
12
11
23
17
17
28,31
30
13