Light Emitting Diodes (Led) On Charger - Stihl AR 900 Manual De Instrucciones

English
2)
During operation: Power tool
switches itself off – allow battery to
cool down for a while.
3)
Electromagnetic problem or
malfunction. Acoustic signal can be
heard as a rapid series of sounds
lasting several seconds – see also
"Acoustic Signal". Disconnect
battery from power tool, take it off
your back, observe battery and
contact your STIHL servicing dealer
immediately – see also
"Troubleshooting".
4)
Electromagnetic problem or
malfunction. Take the adapter out
of the power tool and refit it. Switch
on the power tool – if the light
emitting diodes still flash, the power
tool has a malfunction and must be
checked by a STIHL servicing
dealer.
12
Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... indicates the following:
No electrical contact between
–
battery and charger – remove and
refit the adapter
Malfunction in battery – see also
–
"Light Emitting Diodes (LEDs) on
Battery".
Malfunction in charger – have
–
charger checked by dealer – STIHL
recommends an authorized STIHL
servicing dealer.
AR 900