Flex ALC 8 Instrucciones De Funcionamiento Originales página 14

FLEX ALC 8
2) The operating duration was determined with
all activated laser beams.
The operating duration can be extended
if beams which are not required are switched
off by selecting a different operating mode.
Instructions for use
WARNING!
Do not point the laser beam at people
–
or animals.
Do not look into the laser beam.
–
Do not put any optical instruments in the
–
path of the beam.
This measuring instrument generates laser
radiation which may cause blindness.
CAUTION!
Do not use the measuring instrument
–
in a damp, dusty or sandy environment.
Device components may be damaged.
After using the device, immediately switch it
–
off with the On/Off switch in order to block
self-levelling.
If the device is brought from a very cold
–
to a warmer environment or vice versa,
you should allow the device to acclimatise
before using it.
14
If using adapters and tripods, ensure that
–
the device is screwed on tightly.
The most important operating steps are
explained at the end of these instructions
on the illustrated pages.
See from page 146.
Battery charging with USB cable and
USB charger ............................................... 146
Switching the device on and off ................. 148
Selecting the operating mode .................... 150
Switching over ambient mode ................... 152
Testing the horizontal beam ...................... 154
Checking precision
It is recommended to check the device
regularly to ensure that it is always precise.
If the precision deviates from the permitted
tolerance range, the device must be taken
to a customer service workshop authorised
by the manufacturer.
Have the device adjusted by authorised
technicians only.
The steps required to check the precision
are explained at the end of these instructions
on the illustrated pages. See from page 154.