Operation - Danby Silhouette DURH301SSSL Manual Del Usario

3.Temporarily position the rangehood in its intended place.
Using a pencil measure, mark the mounting holes, duct and
electrical locations.
4. Drill/cut out the required openings for duct and electrical
access; ensure the damper/duct connector enter the ductwork
and the damper opens and closes freely
5. Connect the electical supply wiring (make sure power supply
is off)
6. Leave enough space to apply duct tape to the connection
7. Securely fasten the hood to the cabinet with the mounting
screws
8. Securely fasten the hood to the wall with the mounting
screws
9. Install the filters

OPERATION

Always turn the hood ON before cooking in order to establish
an air flow in the kitchen. After turning off the range, let the
hood run for a few minutes to clear the air.
Power
To activate the rangehood, press the power button. Once acti-
vated, the buttons and LED light up.
Light
The Silhouette Select™ rangehood are equipped with 3 light
settings High, Low and Off. Press the light icon once and the
20w halogen bulbs turn on providing full task lighting. Press
the icon again and this reduces the illumination to 50%. Press
the icon a third time to turn the lights off.
Filter
After 100 hours, the filter icon lights up and the user must re-
move the filter, clean it and replace it in order to reset the icon.
Press and hold the power button for 3 seconds to reset after
cleaning the filter.
Timer
Silhouette Select™ rangehoods include a convenient feature
that allows the range hood to continue to run for an additional
5 minutes to expel residual vapors and odours after cooking.
When the timer button is pressed once the current fan speed
will continue to run for a duration of 5 minutes and the timer
icon appears on the LED display. Push the timer button a
second time to cancel the timer and remove the icon from the
LED display.
Fan
Your Silhouette Select™ rangehood offers 3 fans settings low,
medium and high. To activate the fan press the fan button and
the fan starts at the low setting and the corresponding icon ap-
pears on the LED display. Press the fan button again and the
blower increases to the medium speed. Press a third time for
the highest speed and a fourth time to turn the fan off.
Icon for low speed
Icon for medium speed
Icon for high speed
4