Safety And General Information; Product Description - Omega 66150C Instrucciones De Funcionamiento Y Manual De Piezas

SAFETY and GENERAL INFORMATION

Save these instructions. For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Instructions and Safety information shall be conveyed in the operators native language before use of this
product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with
the use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in
this factory authorized manual, remove from service.
Inspect before each use. Do not use if broken, bent, cracked or otherwise damaged parts are noted. If any com-
ponent of this product has been or suspected to have been subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), discontinue use until checked out by a factory
or manufacturer for list of authorized service
the use and subsequent repair of this equipment may require special training and knowledge. It is recommended
that an annual inspection be done by qualified personnel. If this product appears to be damaged in any way, is
worn or operates abnormally it shall be removed from service immediately and the manufacturer notified. Labels
and Operator's Manuals are available from manufacturer.

PRODUCT DESCRIPTION

This Hydraulic Pipe Bender is designed to be used for pipe bending jobs which do not require cosmetic perfec-
tion. System features welded construction, 8 shoe attachments for a wide variety of tube diameters. It is capable of
bending standard steel pipes schedule
since the pipe is not internally supported.
NOTICE: DO NOT use on pipes intended to contain flammable, explosive, corrosive, or harzardous
materials.
SPECIFICATIONS
Model
66150C
1" Shoe
1 1/4" Shoe
1 1/2" Shoe
2" Shoe
2 1/2" Shoe
3" Shoe
centers).
40 & 80 ranging from 1/2" up to 3" diameter. Pipe distortion will likely occur
Capacity Product Size
15 Tons 31-7/8" x 28-3/4" x 40-5/8"
3/4" Shoe
1/2" Shoe
Pivot Assembly
Base Leg
Figure 1- Model 66150C Nomenclature
Owners and operators of this equipment shall be aware that
Hydraulic
Stroke
Plunger Bracket
Pin Holder
2
authorized service center
Rated Pressure
9-7/8" 10,000 psi
Upper Frame Plate
Lower Frame Plate
Cylinder Bracket
Cylinder
Hydraulic Hose
Handle
(contact distributor
Attachments
(shoe range)
8 pc. (1/2"-3")
Release
Valve Knob
Hand Pump
Oil Filler Screw