Cutting Procedures - Hitachi Koki C 6UY Manual De Instrucciones

Ocultar thumbs Ver también para C 6UY:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
(4) Move the marked wood chip to the front of
the base, and turn the parallelism adjustment
screw so that the marking corresponds to the
base side (Fig. 9).
Wood chip
Parallelism adjustment
screw
(5) After adjustment, fasten the mounting screws
tightly in place.
NOTE
Parallelism may be slightly faulty if the cutting
depth is adjusted after parallelism adjustment.
5.
Adjusting the guide piece
On the circular saw, it is possible to make fine
adjustment of the fixing position of the guide piece,
where the saw blade and the premarked line are
to be aligned.
When the saw is shipped from the factory, the
linear portion of a front scale on the guide piece is
aligned with the central position of the saw blade.
Premarked line
(45˚)
Notoh at 45˚
M4 Screw
Loosen the fixed M4 screw on the guide piece,
should the fixing position be wrong, and make
necessary adjustment of the position (Fig. 10).
6.
Using the dust collector (Optional accessory)
To use the vacuum cleaner to gather up saw dust,
attach the suction hose to the dust collector which
is attached to the main unit by M4 screw (Fig. 11).
10
Fig. 9
Premarked line
(90˚)
Notch when
not inclined
Guide piece
Saw blade
Fig. 10
Dust collector
7.
Adjusting the position of the clamp lever
Depressing the clamp lever disengages it from the
bolt head, leaving it free to rotate.
After securely fixing the guide and the guide rail,
depress the clamp lever and rotate it to a position
in which it will not interfere with cutting operation
(Fig. 12).
Clamp lever

CUTTING PROCEDURES

WARNING:
● Do not use any abrasive wheels.
● Never touch the moving parts.
● As shown in Fig. 13, be sure to hold the round
handle securely with both hands when cutting.
Contact with "live" wire will make exposed metal
parts of the power tool "live" and shock the
operator. In addition, make sure to secure the
work piece with a clamp when cutting.
Fig. 11
Head of bolt
Fig. 12
Fig. 13

Publicidad

Tabla de contenido
loading

Tabla de contenido