Work Pro Digiline Serie Manual De Usuario página 15

3.1.2. MIXER
This tab allows to configure which inputs (from the 8 inputs included in the DIGILINE) and which value and state will be
present in the selected output. Therefore, we can create a 8 input/8 output matrix setting their levels.
As much as Master fader or Level fader, the gain level can be set moving the fader or typing the value in the cell.
Also, it is posible to change the state of each input (MUTE (in red colour), INVERT (yellow color) or active (both
icon not highlighted)
Like each DSP section, a command sentence will appears in OSC HISTORY each time that we change any value.
In that case, the last action has been to change de Gain value of the Input 5 applied to Output 1 and changing the
state to MUTE.
3.1.3. XOVER
This tab allows to create two crossover filters: High Pass Cut and Low Pass Cut.
For both filters we can configure the frequency (fc), the type of filter to select between three types (Butterworth,
Linkwitz-Riley or Bessel) (Type), and the magnitude order of that filter (Up to 8 orders) (N).
The obtained response curve applying both filters is displayed on the screen. The horizontal axis shows the
frequency in Hz and vertical the gain in dB.
MX
MKII
PAGE 14