Attaching The Front Cover - Yamaha Soavo-3 Manual De Instrucciones

ATTACHING THE FRONT COVER

The speaker and the front cover are packed separately. To
attach the front cover, line up the six salients (magnet) on the
reverse side of the front cover with the six corresponding pegs.
Notes
• When the cover is not attached, take care not to touch
the speaker units with your hands or to exert excessive
force with tools.
• There are magnets on the reverse side of the front
cover. Do not place the front cover close to objects that
might be affected by magnets, such as TVs, clocks,
magnetic cards, diskettes etc. when you don't attach it.
5
En
SPECIFICATIONS
Type ............................3-way 3-speaker Bass Reflex speaker
Driver............................................ 16 cm (6-1/2") cone woofer
Impedance ........................................................................ 6 Ω
Frequency response ......................35 Hz to 50 kHz (
Nominal input power .......................................................40 W
Maximum input power ...................................................160 W
Sensitivity ....................................................... 87 dB/2.83 V/m
Crossover frequency ......................................450 Hz, 4.5 kHz
Dimensions (W x H x D)
Including stands ................................349 x 1051 x 487 mm
Weight ...................................................26.5 kg (58 lbs. 7 oz.)
• Specifications are subject to change without notice due
to product improvements.
• Care should be taken not to exceed the input power
values noted above.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents
(e.g., alcohol or thinners etc.): this might damage the
finish. Use a clean, dry cloth. For difficult soils,
dampen a soft cloth in water, wring it out, and then
wipe with the cloth.
Non-Magnetic shielding type
13 cm (5") cone midrange
3 cm (1") aluminum dome tweeter
–
to 100 kHz ( –
(13-11/16" x 41-3/8" x 19-3/16")
10 dB)
30 dB)