Vent appearance and location vary.
Pull the knob straight off the stem.
Oven Air Vents
Never block the vents (air openings) of the
range. They provide the air inlet and outlet
that are necessary for the range to operate
properly with correct combustion.
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe the control panel
after each use of the oven. Use a damp
cloth to clean or rinse. For cleaning, use
mild soap and water or a 50/50 solution of
vinegar and water. For rinsing, use clean
water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish.
Do not bend knobs by pulling them up or
down or by hanging a towel or other such
loads. This can damage the gas valve shaft.
Porcelain Oven Interior
With proper care, the porcelain enamel
interior will retain its attractive finish for
many years.
Soap and water will normally do the job.
Heavy spattering or spillovers may require
cleaning with a mild abrasive cleanser.
Soap-filled scouring pads may also be used.
Do not allow food spills with a high sugar or
acid content (such as tomatoes, sauerkraut,
fruit juices or pie filling) to remain on the
surface. They may cause dull spots even
after cleaning.
Household ammonia may make the
cleaning job easier. Place 1/2 cup ammonia
in a shallow glass pan and leave in a cold
oven overnight. The ammonia fumes will
help loosen the burned-on grease and food.
When necessary, you may use a commercial
oven cleaner. Follow the package directions.
Air openings are located at the rear of
the cooktop, at the top and bottom of the
oven door, and at the bottom of the range,
under kick panel or broiler compartment
(depending on the model).
The control knobs may be removed for
easier cleaning.
Make sure the knobs are in the OFF
positions and pull them straight off the
stems for cleaning.
The knobs can be cleaned in a dishwasher
or they may also be washed with soap and
water. Make sure the insides of the knobs are
dry before replacing.
Replace the knobs in the OFF position
to ensure proper placement.
Metal parts can be cleaned with soap and
water. Do not use steel wool, abrasives,
ammonia, acids or commercial oven
cleaners. Dry with a soft cloth.
Cautions about using spray-on oven
cleaners:
s
Be careful where the oven cleaner is sprayed.
s
Do not spray oven cleaner on the electrical
controls and switches (on some models) because
it could cause a short circuit and result in sparking
or fire.
s
Do not allow a film from the cleaner to remain on
the temperature sensing bulb—it could cause the
oven to heat improperly. (The bulb is located at
the rear of the oven.) Carefully wipe the bulb
clean after each oven cleaning, being careful not
to move the bulb as a change in its position could
affect how the oven bakes.
s
Do not spray any oven cleaner on the outside
oven door, handles or any exterior surface of the
oven, cabinet or painted surfaces. The cleaner can
damage these surfaces.
ge.com
25