Installation Instructions; Before You Begin - GE JGBS09 Manual Del Propietario E Instrucciones De Instalación

Installation
Instructions
If you have questions, call 800.GE.CARES or visit our Website at: ge.com
In the Commonwealth of
Massachusetts:
• This product must be installed by a licensed
plumber or gas fitter.
• When using ball-type gas shut-off valves, they
shall be the T-handle type.
• A flexible gas connector, when used, must not
exceed 3 feet.

BEFORE YOU BEGIN

Read these instructions completely and
carefully.
Installation of this range must conform
with local codes, or in the absence of local
codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA.54, latest edition. This
range has been design-certified by CSA
International according to ANSI Z21.1,
latest edition and Canadian Gas Association
according to CAN/CGA-1.1 latest edition.
As with any appliance using gas and
generating heat, there are certain safety
precautions you should follow. You will find
these precautions in the Important Safety
Information section in the front of this
manual. Read them carefully.
IMPORTANT –
•
instructions for local electrical inspector's use.
IMPORTANT –
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Note – This appliance must be properly
grounded.
• Servicer – The electrical diagram is in an
envelope attached to the back of the range.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under the Warranty.
26
Range
Save these
Observe all governing