Klarstein 10032903 Manual De Instrucciones página 30

EN
30
Replacing Bulb
WARNING: Risk of electrical shock
Always switch off the electricity supply before carrying out any
operations on the appliance.
General notes
• The bulb must be replaced by a costumer service or similarly qualifi ed persons.
• When changing the bulb, make sure it has completely cooled down before
touching it directly with your hands.
• When handling the lamp use a cloth or gloves so that it does not come into contact
with sweat, as this may reduce its service life.
To change the bulb, proceed as described below:
1 Switch off the appliance and unplug the power cord from the wall outlet.
2 You should use a suitable screwdriver to loosen the screws holding the panel into
place. Once this is removed, you will have access to the light.
3 Take out the lamp. Open the terminal box that connected with the wire, disconnect
the wire connector and replace the lamp
4 Once the LED light has been replaced, remount the panel by rescrewing the screws
again.
Technical data of the lamp:
ILCOS D code:
LED modules
Max wattage:
Voltage range:
Dimensions:
DBS-2.5/65-H-120/33
– rectangle lamp
2.5 W
AC 220-240 V