Care And Cleaning; Troubleshooting - Defiant DF-5936-BK Guía De Uso Y Cuidado

Operation (continued)
Completing motion sensor
7
setup
After all motion sensor (C) adjustments are
complete, rotate the motion sensor (C) so the
controls are facing the rear of the fixture (B)
and the two dots are in alignment.

Care and Cleaning

To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come on.
The light comes on during the
day.
Possible Cause
The light switch is turned off.
The fuse is blown or the circuit breaker
is turned off.
Daylight turn-off (photocell) is in effect.
The circuit wiring is incorrect (if this is
a new installation).
The outside air temperature is close to
the same as a person's body heat.
The motion sensor may be installed in a
relatively dark location.
The "LUX" control is turned to the " + "
position.
9
B
C
Solution
Please contact 1-866-308-3976 for further assistance.
Turn the light switch on.
Replace the fuse or turn the
circuit breaker on.
Recheck after dark or turn
the "LUX" dial toward the
" + " position.
Verify the wiring is correct.
Increase the "SENS"
setting.
The light fixture is operating
normally under these
circumstances.
Turn the "LUX" dial toward
the " – " position.
HOMEDEPOT.COM