Basic Operations; Turn On Stb; Power; Channel Up/Channel Down - Engel RS8100HD Manual De Usuario

Basic Operations

2.
2.1

Turn on STB

Use the Power Switch at the back of Receiver Rear
Panel to Turn ON the unit.
?
Frequently Asked Question
Q: the power of my STB has been turned on and not
in Standby mode, but the TV screen showed
nothing:
A: Make sure the Connections are connected properly;
check the Input source of LCD/TV, For example, if you
have connected the receiver to the Video1 input of the
LCD/TV, then TV set has to be switched to Video1.
When all the above mentioned steps are corrected but
problem continues press V-MODE key several times to
change the Video mode from receiver.
Q: The power of my STB has been turn ON and not
in Standby mode, but the TV screen showed
nothing except "one ball with No Signal image".
A: That means the channel, which you select, has no
signal. It could be several causes:
1 The channel which you select is not in your
allocate satellite. The simple solution is to change
channel.
2 The signal of current TV channel is too weak. You
can try to change channel to other strong signal
channels. If the problems still exist, please consult
your local dealer or other professionals for
technical service.
3 If You use the Dual LNB/Multiswitch or Multiple
satellites, then and you need Modify the LNB type
Antenna Setup
Follow the page
2.2

Power

1 Pressing [Power] Key can enter the Standby state
2 In Standby state, pressing [Power] Key again can
call back the unit to live mode and play the
previous channel
3 User can also disconnect the device's main power
to end the Standby state.
2.3

Channel Up/Channel Down

In Live TV mode, press [PR+/PR-] to change channels.
2.4

Volume Up/Volume Down

In Live TV Mode, press [VOL+/VOL-] to adjust volume.
2.5

Number

In Live TV mode, use number key and press [OK] on the
Remote Control Unit to jump change.
2.6

Mute

1 Press [MUTE] key to mute the sound and the
screen will show up mute OSD.
2 Press [MUTE] key again to restore sound.
2.7

Pause

1 In playing mode, press [Pause] key, the picture will
be paused, but the sound of the channel will still
continue.
2 Press [PAUSE] key again, the screen's picture will
skip over to the current playing picture, and the
sound of the channel will correspond playing.
2.8

FAV

1 In full screen, press [FAV] key, it will display a
window of "Favorite" Group on the left of the
screen, which you can see like below.
2 In the window of "Favorite", you can move highlight
by press [Channel Up/Channel Down] key and
press [OK] key to select favorite group.
3 In the window of "Fav group X", you can move
highlight by press [Channel Up/Channel Down]
key and press [OK] key to select favorite channels.
3