Declaration Of Conformity - Beta 1946C4,8 Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS
• Make sure that the air supply of the air riveter has been disconnected; remove the nozzle holder, then the rubber protection
cover; finally, use a round pin wrench for ring nuts with front holes to remove the lower part of the air riveter and the cover under
the cylindrical body (picture 4).
• Pull out the entire piston unit with a pair of pliers.
• Fill up with oil to the level of the lower part of the central bush. Use hydraulic oil ISO 32.
• Fit in the entire piston unit, tightening the screw by hand with the wrench.
• Adjust the head unit (as shown above), and install the nozzle holder.
LUBRICATION
The pneumatic tool must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil
microfog mixer, set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 6).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre through your Beta dealer.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force
in your country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month
warranty for professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or
replacing them at our discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty
will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition,
this warranty will no longer be valid if any changes are made, or if the pneumatic tool is forced or sent to the
customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions
of Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-1
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
12

DECLARATION OF CONFORMITY


EN