Assembly - RIDGID RD80701 Manual Del Operador

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
wARNING:
Do not use this product if any parts on the Packing
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Pressure Washer
Trigger Handle Rest (front and back)
Screw (4)
Lock Nut
Flat Washer
Front Support
Hex Nut (2)
30 ft. High Pressure Hose
Auxiliary Handle
Trigger Handle
Spray Wand
Nozzle Holder (with Quick-Connect Nozzle (3) and Dual
Power Soap Nozzle)
Wheel (2)
Washer (2)
Axle (2)
Hitch Pin (2)
4-Cycle Engine Oil (SAE30 or SAE 10W30)
Operator's Manual
wARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
wARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
wARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug when
assembling parts.
ATTAChING ThE FRONT SUPPORT
See Figure 2.
 Lift the machine and slide the front support into the front
tubes.
 Push the screw into the holes in the front tubes. Tighten
securely using the hex nuts.
ATTAChING ThE whEEL ASSEMBLY
See Figure 2.
 Locate the axle, hitch pins, washer, and wheels. Remove
the hitch pin from the axle.
 Slide the axle through the hole in the center of the wheel.
 Slide the washer onto the axle.
 Lift the machine and slide the axle into the wheel mounting
hole in the machine base as shown.
 Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
 Repeat with the second wheel.
ATTAChING ThE TRIGGER hANDLE REST
See Figure 3.
 Locate the trigger handle rest (front and back), screws,
and lock nut.
 Push the screws into the holes. Tighten securely using
the lock nut.
CAUTION:
Failure to remove pump oil plug label may result in
decreased pump life.
REMOvE ThE LABEL AND ShIPPING PLUG
See Figure 4.
Remove pump oil cap label and shipping plug from the oil
pump.
8 — English