Black+Decker LPP120 Manual De Instrucciones página 11

Chain Oiling
• A high quality bar and chain oil or
SAE30 weight motor oil should be
used for chain and bar lubrication.
The use of a vegetable based bar and
chain oil is recommended when pruning
trees. Mineral oil is not recommended
because it may harm trees. Never use
waste oil or very thick oil. These may
damage your chain saw.
• Lubricate the whole chain evenly before each use as shown
in figure 6. Also lubricate the chain whenever replacing a fully
discharged battery with a fully charged one.
Transporting Pole Saw
• Always remove the battery pack from the handle (figure 7) and cover
the chain with the scabbard (figure 8) when transporting the Pole
Saw.
7
ASSEMBly
Joining Saw Head Module to Handle Module
WARNING:
Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective scabbard is in place on the chain before
performing the following operations. Failure to do this could
result in serious personal injury.
The three modules which make up the Pole Saw are keyed to insure
correct assembly. If a module does not smoothly attach to another do
not force fit.
Combining the handle module (A) to the saw head module (C)
6
8
creates a pole saw that is approximately 6 foot in length as shown in
figure 9.
9
To attach the handle module to the saw
head module:
1. Align the groove on the outside of the
coupling end of the handle module (A)
with the tongue on the inside of the
coupling end of the saw head module
(C). See figure 10. Push the two
sections completely together.
2. Slide the threaded sleeve (6) figure 11
on the saw head module down as far as
possible and rotate the sleeve clockwise
until it stops and completely covers the
orange threads as shown in figure 12.
WARNING:
Always check to make
sure that the sleeve is completely
threaded on and that the orange
threads are no longer visible. Not
threading the sleeve completely on could
result in the modules becoming disconnected creating a hazardous
condition. Periodically check the connections to insure that no
orange threads are visible.
Joining Center Extension to Saw Head Module and
Handle Module
Adding the extension (B) to the handle module (A) and saw head
module (C) creates a Pole Saw that is approximately 9 foot in length
as shown in figure 13.
13
11
10
Groove
11
12