TECshow BEAMPIX 14 Manual De Usuario página 9

58
59
60
6. TROUBLE SHOOTING
Following are a few common problems that may
occur during operation. Here are some sugges-
tions for easy troubleshooting:
A. The unit does not work, no light and the fax
does not work.
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX Controller.
1. DMX LED should be on. If not, check DMX con-
nectors, cables to see if link properly.
2. If the DMX LED is on and no response to the
channel, check the address settings and DMX
polarity.
3. If you have intermittent DMX signal problems,
check the pins on connectors or on PCB of the
unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run along-
side to high voltage cables that may cause dam-
age or interference to DMX interface circuit.
0-255
000-007
008-12
13-16
17-20
21-24
......
227-247
248-255
0-255
C. Some units don't respond to the easy control-
ler.
1. You may have a break in the DMX cabling,
2. Wrong DMX address in the unit, Set the proper
D. No response to the sound.
1. Make sure the unit does not receive DMX signal.
2. Check microphone to see if it is good by tap-
Warm White 14 Dimmer 0-100%
Color Chase
No function
Color chase 1
Color chase 2
Color chase 3
Color chase 4
......
Color chase 59
Sound controlled strobe
Speed control slow-fast
Check the LED for the response of the master/
slave mode signal.
address.
ping the microphone.
P. 9
English version | Tecshow Beampix 14