Switching The Maschine On; Material Feed - Intimus 175 hybrid Instrucciones De Uso

GB
NOTE!
The motor is switched off when this display
flashes. The motor can only be restarted when
the empty oil container has been replaced
with a full container.
b) „Oil sensor defective"
The control display flashes slowly when the oil
sensor does not operate. Please notify your dea-
ler.
NOTE!
When the oil sensor ist defective you can
switch on the shredder only 30 times. Then the
machine is locked to prevent possible dama-
ges to the cutting mechanism.
= Control display (fig . 3/9)
9
For the procedures see the relevant description
under the section „Malfunctions", p. 16.
a) „Material jam in machine"
Comes on when too much material has been
fed into the cutters. The cutters jam, then run
in reverse for a short time and stop. The motor
switches off.
b) „Light barrier covered when door open"
Comes on when there is still material in the feed
slot when the door is opened. The cutters stop.
The motor switches off.
c) „Light barrier covered when machine turned
on"
Comes on when there is still material in the feed
slot when the machine is switched on.
= Control display (fig . 3/10) „Load level of the
10
motor"
Displays the current load level of the motor during
the shredding process via different colour lights
(see description under „Dynamic load display",
p. 15).

3 .2 Switching the maschine on

Press the function button (fig. 3/1) briefly.
¾ The function button LED display
"Ready".
¾ The machine can be loaded.
14

3 .3 Material feed

The light barriers (forward operation) (fig. 1/3) start the
shredding process as soon as material is inserted into
either of the feed slots.. At the same time the integral
forward button (fig. 3/2) LED display
The shredded material is being catched separatly in
the two receptacles standing side by side.
Feeding of paper:
Feed paper to the cutting mechanism through the
right-hand feed slot (wide slot).
¾ Machine switches automatically to forward and
¾ The machine switches off automatically after
comes on for
If the machine is not used for a period of approx.
15 mins., it automatically switches off.
Feeding data media:
Feed the relevant data media (CD or DVD) individually
to the cutting mechanism through the left-hand feed
slot (narrow slot).
¾ Machine switches automatically to forward and
¾ The motor switches off automatically after
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
CAUTION!
Damage to the machine!
Ì Never feed the shredder with a quanti-
ty of material exceeding the maximum
indicated. Refer to „Technical Data",
p. 18!
Ì Should the machine become overloa-
ded, follow the instructions under „Ma-
terial jam in the machine", p. 16.
NOTE!
It is not possible to feed CDs and paper at the
same time. The cutting mechanism switches
off in such an event. (See „Material jam in the
machine", p. 16.)
draws paper in.
shredding.
NOTE!
For shredding transparent films, the machi-
ne must be manually switched to forwards
running (press and hold the forwards button
(fig. 3/2)).
The shredding process can be stopped at any
time by briefly pressing the function (fig. 3/1)
or reverse button (fig. 3/6). Press the forward
button (fig. 3/2) to continue.
draws material in.
shredding.
comes on.
93901 5 01/18