DeWalt DW735 Manual De Instrucciones página 6

3.Slide t henotches inthedust p ort o ver t hepins onthechip
ejection chute.
4.Rotate t heport u ntil thebutton engages thedust e jection chute
and locks i nplace.
,_WARNING: DO NOT OPERATE YOUR PLANER WITHOUT THE
DUST EJECTION PORT LOCKED INTO PLACE. DO NOT INSERT
ANYTHING INTO THE DUST EJECTION CHUTE UNLESS THE
PLANER IS UNPLUGGED AND YOU ARE CLEARING A CLOG OR
OBSTRUCTION IN THE UNIT. DO NOT GET YOUR FACE OR EYES
NEAR THE DUST EJECTION PORT WHEN THE PLANER IS IN
OPERATION. SERIOUS INJURY COULD RESULT.
WARNING: Chips are ejected at significant velocity. Keep hands
and face clear of dust ejection port.
TO REMOVE THE DUST EJECTION PORT
1. Use the T-wrench to depress the lock button on the dust chute.
2. Twist the port until the pins are disengaged from the notches on
the port.
3. Pull the dust ejection port off of the dust chute.
OPERATION
_WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
On/Off Switch
To turn the planer on, lift the switch (L) up.
The planer locks on automatically. To turn the
tool off, press the switch down. A hole is
provided under the switch (M) for insertion of a
padlock to lock off the planer.
Depth Adjustment
DEPTH ADJUSTMENT SCALE
The depth adjustment scale (N), located
on the right front of your planer, indicates the
finished thickness of your workpiece. One
rotation of the depth adjustment crank is equal
to 1/16", half rotation is equal to 1/32", etc.
DEPTH ADJUSTMENT CRANK
Turning the crank clockwise lowers the cutter
head. Turning the crank counterclockwise raises
the cutter head.
Material Removal Gauge
Your planer is equipped with a material
removal gauge (O). It is used to indicate the
amount of wood that will be removed in one
pass with the carriage set at its current
height.
TO USE THE MATERIAL REMOVAL
GAUGE
1. Slide approximately 3" of your material under the middle of the
carriage.
2. Be sure the wood is lying flat against the base of the planer.
If the material is inserted at an angle, the reading may be
inaccurate.