Control Panel Description; Programming Time Functions; Setting The Time Of Day; Electronic Control - Fulgor Milano F1SP241 Serie Manual De Uso & Mantenimento

Control panel description

The oven control panel is made with one display and
two knobs.
- Time & Temperature display.
- Time & Temperature knob (Push & Shuttle).
- Mode (oven functions) knob.

Programming time functions

At every power-up, the control shows the time of day
blinking, set at 12:00
AM
increases every minute. The only possible action is
the "Clock Regulation", all other oven operations are
inhibited.
In general, turn the Temp/Time selector left or right in
order to edit the values and modify them by steps; hold
the knob on the left or right to fasten the decrease/
increase operations.

Setting the time of day

The time of day is always displayed in the 12:00
hours format. Hours and minutes are set separately.
In order to set the time of day, mode selector must be
in ZERO position, the -/+ knob acts on the time of day
by default.
- Turn the selector left/right, the hours flash.
- Modify the flashing hours value turning the selector
left/right.
- Push the Temp&Time selector to switch back and
forth between hours and minutes.
- Modify the flashing minutes turning left/right.
- After a few seconds the whole time of day value
starts flashing: wait until the new time of day is
steady.
Push the knob to toggle between the time of day and
the minute minder and check the set values. The clock
is selected by default while the
when the minute minder is displayed.
10

Electronic control

MODE
as the initial value. The time
symbol appears
The push & shuttle knob is mainly for clock or
temperature setting and automatic time functions
programming. Select the desired item by pushing the
knob.
TEMP & TIME

Setting the minute minder

When the symbol is displayed, turn the knob left/
right in order to set the timer value.
The standard value is 30 minutes, it's possible to
modify it in the range between 0 and 240 minutes.
This timer has no influence on the oven activities and
can be set also when the oven is off. The time of day
is displayed with priority in any case, the
shows the minute minder is active.
When the time expires, the
buzzer sounds a warning sequence (two short beeps
repeated every 3 seconds) to recall the user attention.
Push the knob to stop it.
AM/PM The buzzer stops in any case after a time-out.

Buzzer volume

The buzzer volume can be set turning the Time&Temp
knob to the left when the control is in light mode. At any
detents the buzzer sounds a double beep, selecting
the volume out of three available levels. The buzzer
must always be silent between 22:00 and 8:00.
Temperature Unit Measurement
To select Fahrenheit or Celsius press +/- knob twice,
when the display shows F or C turn +/- knob to
change the unit on measurement, press again +/-
knob to confirm.
Use & Care Manual
ENGLISH
symbol
symbol flashes and the