Connecting The Lcd Tv To A Pc; Connecting To A Dvd Player - CONTINENTAL EDISON CETVLCD40FHDR3 Manual De Instrucciones

to use USB hard disk drives for recording HD
programmes.
• Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
• Multipartition HDDs are supported until two
partitions.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.

Connecting the LCD TV to a PC

For displaying your computer's screen image on your
LCD TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use a 15-pin D-sub display cable
to connect a PC to the LCD TV. When the connection
is made, switch to PC source. See "Input selection"
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts.
Audio inputs of the TV
PC audio cable
(not supplied)
Audio output of the PC
PC input of the TV
PC VGA cable
(not supplied)
Monitor output of the PC
English - 46 -

Connecting to a DVD Player

If you want to connect a DVD player to your LCD
TV, you can use connectors of the TV set. DVD
players may have different connectors. Please refer
to your DVD player's instruction book for additional
information. Power off both the TV and the device
before making any connections.
Note: Cables shown in the illustration are not
supplied.
• If your DVD player has an HDMI socket, you can
connect via HDMI. When you connect to DVD player
as illustrated below, switch to HDMI source. See,
"Input Selection" section.
• Most DVD players are connected through
COMPONENT SOCKETS. Use a component video
cable to connect video input. For enabling audio,
use a component audio cable as illustrated below.
When the connection is made, switch to YPbPr
source. See, "Input selection" section.
• You may also connect through the SCART 1 or
SCART 2. Use a SCART cable as shown below.
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.