Dicore ASDGR09AYR Manual De Usuario página 75

Introduction for buttons on remote controller
16 Combination of "+"
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote
controller is locked,
three times.
17
Combination of "MODE " and "-" buttons :
At unit OFF, press
18
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
Press "TEMP" and "CLOCK" simultaneously in COOL mode to start energy-saving function.
Nixie tube on the remote controller displays "SE". Repeat the operation to quit the function.
19 Combination of " TEMP " and "CLOCK" buttons : About 8ºC
Press "TEMP" and "CLOCK" simultaneously in HEAT mode to start
Nixie tube on the remote controller displays "
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
℉
20
About Back-lighting Function
The unit lights for 4s when energizing for the first time, and 3s for later press.
For Cold plasma & Air detect function
★
1) AC starts with Cold Plasma ON and Air detector do not check air standards. After 30
minutes Cold Plasma should power off.
2) After 30 minutes, Air detector starts to collect air data from surrounding to set a standard
air quality level.
3) After setting a standard level, Air detector will keep collecting data from surrounding to set
a new air quality level. Then it will compare the new one with the standard one to consider
the air status surrounding as terrible,middle or good.
4) A, If air status is good, cold plasma will not start and nothing will show on display.
B, If air status is middle, cold plasma will start working but nothing will show on display
either. A beep will sound to indicate start of Cold Plasma.
C, If air status is terrible, cold plasma will start working (a beep will sound to indicate start
of Cold Plasma) and display will show "CP".
5) If you don't satisfy with the air status but the Cold Plasma is not running, you can start
Cold Plasma artificially by pressing "Health" button on remote control.
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
Notes:
★
●
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
●
If the remote controller will not be used for a long time, please
remove batter ies to prevent batteries from leaking.
●
The operation should be performed in its receiving range.
●
It should be kept 1m away from the TV set or stereo sound sets.
●
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly ,
replace the batteries.
and "-" buttons: About lock
is displayed. In this case, pressing any button,
" "
"- "
MODE
and buttons simultaneously to switch between
Replacement of Batteries
About switch between Fahrenheit and centigrade
Heating Function
" and a selected temperature of " 8ºC "
12
blinks
and
℃ ℉
8ºC Heating Function
.
Sketch map for
replacing batteries
.