How It Works; Setting Up The System - Unisar TVLISTNER J3 920 Manual De Instrucciones

How It Works

The TV Listener J3 works just like your remote control, sending an invisible infrared
signal from your television or any other audio device to the deluxe stereo headset.
Unlike radio frequency devices, infrared is not subject to interference from cordless
phones, wireless networks, microwaves, etc. You adjust the volume on the wireless,
lightweight headset to suit your personal needs. Multiple headsets can be used
with one transmitter.

Setting Up the System

Charge the batteries in the headset for 16 hours prior to first use.
TV Listener J3 Components
Check that you have all the following components before installation.
Transmitter
(connects to your TV or other audio device)
Infrared Rays
Wireless Headset
Power
Indicator
Light
Power
Switch
Volume
Control
{ }
4
Power Switch
AC Adapter Jack
Charging
Adapter
Headphone
Adapter
Battery
Compartments
Infrared
Sensors
Charging
Charging
Indicator Light
Infrared Sensors
Jack
AC adapter
RCA 3.5mm stereo adapter
RCA 3.5mm mono adapter
Installation of the Transmitter
The following are the five different ways to connect the TV Listener J3. Your installation
will depend on the type of equipment you have.
1. STEREO INSTALLATION – for equipment with two audio output jacks (stereo televi-
sions, DVD players, cable boxes). Refer to Pg. 6.
2. MONO INSTALLATION – for equipment with only one audio output jack (mono televi-
sions, DVD players, cable boxes). Refer to Pg. 6.
3. SMALL HEADPHONE JACK INSTALLATION
jack (most CD players, portable stereos, MP3 players). Refer to Pg. 7.
4. LARGE HEADPHONE JACK INSTALLATION
jack (some home stereo systems). Refer to Pg. 8.
– for equipment that does not have any audio output
5. MICROPHONE INSTALLATION
jacks. Refer to Pg. 8.
6.3mm stereo headphone adapter
Microphone adapter
2 AAA rechargeable batteries
– for equipment with a small headphone
– for equipment with a large headphone
{ }
5