Location Requirements; Water Supply Requirements; Drain System Requirements - Haier HLPW028BXW Manual Del Usuario

LOCATION REQUIREMENTS

IMPORTANT:
Do not install or operate the washer where it will be exposed to
temperatures below 32°F (0°C). Water remaining in the washer will freeze and
cause damage to the washer.
•
The washer must be installed on a solid floor to minimize vibration during the
spin cycle. A concrete floor is the best.
•
The floor should be level with maximum slope of 1" (25 mm) under entire washer.
•
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
•
Do not install on carpeting.
•
The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of
power cord on the back of the washer.
•
Hot and cold water faucets must be present within 3 ft. (0.9 m) of the hot and
cold connections on the washer.
•
This appliance must be operated at room temperature.
PRODUCT DIMENSIONS

WATER SUPPLY REQUIREMENTS

•
A water heater must supply hot water with a temperature of at least 120°F
(49°C).
•
The water pressure should be between 20 and 120 psi (138 to 827 kPa).

DRAIN SYSTEM REQUIREMENTS

IMPORTANT:
•
Do not lay the drain hose on the ground. A portion of the drain hose must
be kept higher than the water line inside the wash basket or the fill water will
run out of the drain hose and the washer will not work correctly.
•
The end of the drain hose cannot be immersed in water for the washer to
work properly.
37⅝ "
(95.6 cm)
22¹⁄₁₆ "
(56.0 cm)
21²⅓₂ "
(55.0 cm)
7