Bridge Function - Fagor PBP5VI502FTB5 Manual De Instrucciones

OPERATION
The stop'n go function can be used for maximum 10 minutes. If the stop'n go
function does not finish in this period, the panel sensor switches off.
If control has been accidentally turned on by
pressing the on/off sensor (1), the stop'n go
function helps you to quickly restore the previo-
us settings. If you have deactivated the panel by
pressing the on/off sensor (1), in 6 seconds or
less you have to press the sensor again (1). On
the indicators of heating zones (4) „0" will appe-
ar and above the sensor (11) – the signal LED
will start to blink. Then you have 6 seconds aga-
in to press the sensor (11). The settings light up
on the indicators of heating zones (4) that were
set before the accidental switching off of control.

Bridge function

This function makes it possible to control 2 heating zones on the hob as if they were a single
heating zone.
The Bridge function is very helpful, especially when you use the baking-pan type of pots.
The function can be activated for two zones
on the left side and two on the right side. To
activate the function press two sensors at the
same time. For two heating zones on the left
side you press sensor (+) (2) of the front left
heating zone and sensor (-) (3) of the back
left heating zone. For two heating zones on
the right side you press sensor (+) (2) of the
back right heating zone and sensor (-) (3) of
the front right heating zone. When you press
two sensors, the „
upper display, and in the lower display - figure
(0). Then, by pressing sensor (+) (2) or sen-
sor (-) (3) located under figure (0), you adjust
heating power.
From then on you control two he-
ating zones using one sensor.
To switch off the bridge function simultane-
ously press again the two sensors that you
used to active the Bridge function. In the di-
splay, figure (0) will come on.
From then on, the heating zones ope-
rate individually.
„ symbol appears in the
11
4
10
2 1
3
11
4
10
2
1
3
4
4
3
2
2
3
11
10
1
61