Connections - Teac AD-800 Manual Del Usuario

After all connections are complete, connect the power
cord's plug to the AC wall socket.
Read the instructions of each device that you intend to use with
this unit.
Be sure to connect each plug securely. To avoid hum and noise, do
not bundle the connection cords.
AD-800 (back side)
Amplifier
LINE
LINE
OUT IN
Tuner, etc.
Example
16

Connections

Wall
socket
Speakers
A
LINE IN/OUT jacks
These jacks transmit an analog 2-channel audio signal. Connect
the components using the included RCA pin cables.
Be sure to connect:
White plug White jack
Red plug Red jack
B
AC Power Cord
After all other connections are complete, connect the plug to an
AC wall outlet.
Be sure to connect the power cord to an AC outlet that
supplies the correct voltage.
Hold the power plug when plugging it into an outlet or
unplugging it. Never pull or yank on the power cord.
Voltage Selection
(General export/North America models only)
Be sure to remove the power cord from the AC outlet before
changing the position of the voltage selector switch.
1. Locate the VOLTAGE SELECTOR switch on the rear panel.
2. Using a flat-bladed screwdriver, set it to the appropriate position
(230 V or 120 V) for the power supply used in your area.
IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
Notes on turning on or off the power
When an amplifier is connected to the AD-800, turn on or off the
power of the AD-800 and the amplifier in the following sequence.
When turning on the power
1. AD-800
2. Amplifier
When turning off the power
1. Amplifier
2. AD-800
(L: left channel)
(R: right channel)