Basic Operation - Teac AD-800 Manual Del Usuario

Turning the unit on or off
Press the POWER button to turn the unit on or off.
When the unit turns on, the display lights.
Check the POWER ON START switches that determine what the
unit does when the power is turned on.
When the power is turned on, and the POWER ON START
(OFF-PLAY-REC) switch for the timer is set to PLAY or
REC
The source set with the POWER ON START (CD-TAPE-
USB) switch starts playback/recording.
The timer recording can only record to cassette tape (page 35).
When the power is turned on, and the POWER ON START
(OFF-PLAY-REC) switch for the timer is set to OFF
The source set with the POWER ON START (CD-TAPE-
USB) switch becomes the active source.
When you do not want to use the timer, be sure to set the OFF-
PLAY-REC switch to the OFF position to prevent accidentally
recording over an important cassette tape.

Basic Operation

or
Selecting a source for playback/recording
Each time the SOURCE button is pressed, the source changes as
follows:
The selected source is shown on upper left of the display.
During recording, the source cannot be changed.
Pressing the play button for a source also selects and starts
playback of that source.
Select "LINE" to use an external source connected to the LINE
jacks.
Listening with headphones
To listen with headphones, turn the LEVEL knob to minimize the
volume level before connecting the headphones plug to the
PHONES jack. Then, adjust the volume after connecting the plug.
CAUTION
Do not connect headphones with the PHONES jack while wearing
them. Moreover, do not disconnect headphones or turn the unit
on or off while wearing them. Very loud sound could be output
from the headphones.
AVOID DAMAGING YOUR HEARING—Do not put on headphones
until after plugging them in.
17