Call Transfer - Fonexion ideus ITDECT200 Manual De Usuario

USER GUIDE

Call transfer

During a call, you can transfer the call to another handset.
During a phone call, press
internal handset with which they wish to connect.
The destination handset will ring. With the melody defined for an internal call.
Press the or
The two internal handsets will be connected. To complete the transfer of the call, the
initiating handset should be placed on the cradle and the external call will now be
connected to the second handset.
Party conference call
When a call comes, press (Handset1)
Then press (HS1)
internal handset with which you wish to connect.
The destination handset will ring.
Press (Handset2) the
Press (HS1) the
Press to quit the party conference, and other parties can also continue to
communication.
Locking the keypad
Press and hold the
to idle mode. Repeat the operation to unlock.
10 TROUBLESHOOTING
The ringtone is too low
Check if the ringing volume is properly set. If still doesn't work restore to the factory settigns.
Receive only
Check if P/T mode is properly set.
Check if you have set the barring number, if you want dial out this number, reset the barring
number.
The base can not page the handset
Repeat the registration operations to register the base and handset again.
If the base has registered 5 handset, you can delete one handset and register the handset you
need.
Most of the functions failed
Check if the batteries are sufficiently charged, re-charge the batteries.
If batteries are ok, remove the battery, unplug the lines and reinstall after 10 minutes.
key once, you will be prompted to select the number of the
key of the other handset to accept the call.
key once, you will be prompted to select the number of the
or key to accept call.
key then you can talk all together.
key for about 2 seconds. You will hear a beep tone, the unit will go back
or key
ITDECT200
29
EN