Clock Output Frequency Setting - Esoteric G-02X Manual Del Usuario

Clock output frequency setting

You can set the clock frequency output from the CLOCK OUT
connectors.
o This unit has 2 pairs (A and B) of clock outputs that can be sepa-
rated further into 4 individual outputs (A1, A2, B1 and B2). You can
set the clock frequency independently for each of these outputs.
o By default, the A and B outputs are set to be used as pairs.
Setting A and B outputs by pair (default)
When you change the A setting, the output frequency is set for both
A1 and A2 simultaneously. Follow the same procedure for B.
When "A >" or "B >" appears, pressing the A or B button changes the
output frequency of that pair. Press repeatedly to cycle through the
options.
o Press and hold the A or B button for at least two seconds to set A2
or B2, respectively (See "Setting A2 or B2").
o If you do nothing for ten or more seconds, setting mode will end
and ordinary display will resume. (If DISP is set to SHORT, this will
happen after three seconds.)
Setting A1, A2, B1 or B2
Press the A button for at least two seconds until "A2>" appears. Then,
press the A button to change the A2 setting. You can set different
clock frequencies for A1 and A2. Follow the same procedure for B.
Setting A1 or B1
When A2 is set to any value that is not the same as the A1 setting,
when "A1>" appears, press the A button to change just the A1 out-
put frequency. Follow the same procedure for B.
Setting A2 or B2
Press the A or B button for at least two seconds to set A2 or B2.
When "A2>" appears, press the A button to change just the A2 out-
put frequency. Follow the same procedure for B.
o To set A1 after setting A2, press the A button again after return-
ing to the ordinary display.
o If you set A2 to the same value as A1, "A" will appear again, and
you can set the output frequency used by both outputs in the
A pair simultaneously. Follow the same procedure for B (See
"Setting A and B outputs by pair (default)").
11